The Jalopy Journal
When I had my last 340hp '62 45 years ago I ran a phenolic spacer and blocked the heat riser ports to the carb base and got rid of any vapor lock...
The 60’s were the heyday of these cars everywhere. It didn’t matter much whether you had Chevy, Ford, Pontiac or Mopar the competition was tough...
I don’t think I ever got a t-shirt from that deal. It was a lot of fun. I always wondered if the car ever got finished.
Up again.
Pretty much what Marty says. A lot of are self taught, right or wrong. I have bought most of the metal shaping books by Ron Covel and others over...
I'm no wizard metal mover but I made my hood to and sides from 3003 half hard 050" aluminum sheet. I had a louver press at the time so that was...
I recently bought a set of 4 15x7 Borrani wires RW 3997 dated 1966. Were offered for1958-60 Corvettes. As near as I can tell they were on one car...
BTTT
[ATTACH]
Good job,they are really nice simple cars. I had a '62 for 15 years and traded it for my '40 convert 44 years ago. I drove the Vette enough miles...
Bump
Lower the price from $900 to $850.
A blast from the past for sure Sam. Nice to see you back too.
Well done!
Bump and lower the price.
Bump and lower the price to $60.
Your car looks like it might be the small body like a '40 Chevy. If that is the case maybe a Chevy would work. Mine is just under 17" wide at the...
Incredible stumble into the briar patch.
Here's a chunk cut out of a '32 Firewall a long time ago...time honored hole cut in with a drill and then twisted out. It's just over 21-1/2" wide...
If you go to a rear sump pan and appropriate oil pump make sure you get the matching oil pump shaft. The shaft for the front sump oil pump is...
Thanks Charlie...that's the last bit I needed to know. Thanks all who responded.
I’m repairing a pair of fenders for a pal of mine. There is no evidence of the ring left. Understand about the hole for the horn being flat, but...
Which fender mounting holes have the indented feature (looks like a trim screw washer)? Has anyone seen a patch piece like that , or how would one...
Separate names with a comma.