The Jalopy Journal
300 page Goldenrod tech and history book nearing completion. we are working on a small section near the back about the car touring after the...
Revising my conclusion as this MT article was dated 1953. No way it could be Goldenrod.
Goldenrod body was built in mid-1965 at Sutton's shop. Sutton's grandson provide the pictures for the book. Gary Hooker further confirms this...
Great project. I admire your efforts. It will be a very cool hot rod when its done. Lot of work, but no doubt fun.
Good detailed interview here with Larry Meaux, creator of the famous PipeMax porting software. Discusses porting procedures and describes his...
Pretty good article about prepping and starting a new engine to avoid problems. It's kinda long, but has a lot of good basic ideas to add to your...
Don't have any of them. Trying to track them down. Here's a tear sheet from an old Motor Trend that was in the grandsons scrapbook.. Note caption...
Just been working with his grandsons for photos and memorabilia. They say everyone knew him as Willie and that was confirmed to me by Gary Hooker...
Looking for any photos of Jack Willie Sutton building the body for the Summers Brothers Goldenrod in his North Hollywood Shop. Could also use...
Check out the new Speed Demon wind tunnel test with lots of cool photos and a smoke trail video at:...
Seems like Y-block Fords get more popular all the time. Check out Charlie Burns turbocharged Ford Y-block powering his 1998 GMC Sonoma pickup for...
Hey, Hemi engine guru Gene Adams is finishing up testing of a prototype single four barrel intake manifold for early Hemis. Saw the article on it....
Jimmy, Mike Cook and I did the restoration on the Summers Brothers Goldenrod. Now I am in the middle of laying out the book detailing the entire...
New tech article was just posted about the Kenny Duttweiler built turbocharged small block engines in George Poteet's new Speed Demon. They show a...
Tim, Thanks for all the great build pix for the 2013 Y-block. Great to see real hot rodders out there doing it like it should be done. Congrats on...
That's a pretty good rule of thumb. Maybe multiply the result by 1.1 if you're going to turn more rpm. Also it depends a lot on the intake...
Our family is praying for your daughter. may God bless you and your daughter and grant her a speedy recovery. All our best wishes.
That's a nice list, but a little hard to sort through. If you're looking for vintage Chevy blocks, cranks, heads, intakes, exhaust manifolds and...
Part 2 of the Chevy Mystery Motor story was posted at: http://hotrodenginetech.com/mystery-motor-development-engineer-bill-howell-tells-all/ It...
Anybody see the article about the Chevy 427 Mystery Motors over at hotrodenginetech.com I thought they were all 427s and never realized that...
My buddy bought a new Frank Lockhart book called Frank Lockhart, American Speed King through hotrodenginetech.com. I just looked through it and...
I found this awesome Packard Gold Cup picture over at hotrodenginetech.com http://hotrodenginetech.com/packards-at-speed/ It's from a book...
Separate names with a comma.