The Jalopy Journal
Good insurance Carl :) I have not come to that yet... no space left ;)
Now that's Just what I'm dreaming of !!
Thanks :) I have contacted both Olen at Reactor and Gene now :) KBS
Hi Carl :) They now require SFI approved flex plates and other safety specs to be mandatory. I have spoken to Gene, did not have any. I'm looking...
Hey Carl, you look busy :) It's a stand still here at the moment ;) Do you know of any source that sells SFI approved flexplates that will fit my...
looking good Carl :) No race for me this year, but hope to get it running again next year ;)
Yep Carl, it has gotten over here too ;) What could we do to get rid of it ?? ;) KBS
I beleive that part of the problem, setting up a Flathead on Alky is the low compression. When I say hard to adjust, I meen that the BV are very...
Yes Carl, just fuck with it, and be presistant, then it will pay off. Forget about age, hey you are still playing with cars, only big ones ;)...
Finally got some done this weekend, the new engine is back in the chassis. Some minor work on wiring of the new boxes and it should be ready to be...
Have you found the problem with the Alky Flathead yet Carl ? ;) KBS
Eagle Field Looks amazing :) KBS
Check out SVDA, www.svda.se Vintage dragracing groving year by year :) KBS
We had some of that problems too. Adjusting the BV was a little sensitive. With a secondary bypass, we managed to control the amount of fuel at...
You will figure it out Carl :) What was the issue with it ? Kjell B-S
Thanks, hope it will ;) KBS
As said, retorque and usually it will seal up. I usually resurface the block when rebuilding, and that helps allot. Once I even resurfaced a set...
Slow progress, but With some smal nicks and nucks the New engine will soon end up in the chassis! KBS [ATTACH] [ATTACH]
I belive recreating the past in detail is not possible. I have not been at a SEG event, but juging by videos and pictures, they put on a great...
My first edition had a MSD system with alot of boxes, A Magneto looks and works better ;) KBS
Outch... But you will fixt it Carl. Shit happens.... KBS
Latest report. After useing a copper intake gasket With silicone, I was fed up cleaning the surface when we lift the intake off. I have been...
As most internals are in place, and With a new box of stuff from the US, it's time to do some external stuff. All the New port nozzles are taped...
Sounds much better Carl :) My first and only Dyno time was also a little fiasko. Learned some, but did not get any good numbers. I belive we had...
Have made some progress in these Easter days :-D Just had to mock it up With the New magneto, to see how it fit. One thing for sure, it looks...
As Bored&stroked said Tom Roberts intake. Take a look at historien web Page. The hard way is to make something out of some aluminium ;-) [ATTACH]...
On the last race I managed to break one of the Main caps in the rear end, the Chrysler 8 3/4" could not handle the power from the mighty Flathead...
As a part of the updates on this engine, I desided to change the timing gears to early style for thrusting towards the block. As Bored&stroked...
What rods are going to be used on that beautiful crank Mike? :) My Moldex had to be rebalaced after I had to change the rods, Not so purdy anymore ;)
Thanks guys :) The reason for not D-porting more, is that the ports needs to match the port of the intake runners. Both blocks really looks nice....
Separate names with a comma.