The Jalopy Journal
Metzler would be my brand of choice since they have relatively plain tread patterns, wear like iron, are used on heavy touring/cruzing bikes and...
You didnt say it was a 3 finger pressure plate. Early ford cars ran a 10.5 inch clutch with the 3 finger pressure plate. Say 65 mustang v8. the...
sounds like fox mustang parts. they ran a 164 tooth f.w. and 10.5" clutch. My only q is if its a diaphragm style or not.
stock od in a ford world class t5 is .63... I wouldn't go much taller than that... you will end up having to down shift a lot.
There is a bell housing that mates a t56 to the sbf pattern engines. It cost's about 450 bucks and is a phone call away. It's a commonish mustang...
Lets start out with the disclaimer, I dont know everything. I am a certified welder, do it for a living, dont know everything. While the weld...
I would do hydroboost off of an Astro van. It's a really simple setup that a lot of full size bronco guys do. Parts are readily available and if...
It's an I beam. Straight axles dont have the upturns on the ends to lower ride height. What you are thinking of are twin ibeam's. Argue less, read...
I had magnaflow ultra(?) turbos on my 04 and it sounded very nice. It was deep but not irritating. Sounded CLEAN like it should have from the factory.
Bmf performance in windsor. Owners name is Marc Bean. (970)324-7402. open tues through sat 9-6 I think. He is a performance shop that typically...
Best off looking in mid 70's pickups for a c6. The FMX was the trans of choice for most cars. It's shorter than a c6 but has way less parts...
Are you going to go to a mono leaf too? I got about the same amount of drop on my 62 just by losing the majority of the leaf pack and leaving the...
Nice looking truck JimSwann! someday....
I always thought "traditional hotrodders" used what ever they could use to make their stuff work.
WOW that's some shit to not mess with. Glad you survived. I'm sure you got a severe ass whooping from it all.
When I get to the point of doing the floors on mine I will loose the big gap between the door and floor on mine. I dont like it when you have gaps...
Us army 01-09 Served in iraq 03-04 stationed at Ft. Lewis Wa.
prolly not a good idea. the only mismatch I have ever seen is different heat ranges in holes that burn odd.
That's f'in cool. Nice pics!
Read the thread before you open your pie hole. His ENGINE doesn't have enough. Motors are electric.
AWESOME addition to the garage! Can't wait to read the build.
The coolant that was in my 62 unibody had been there since atleast 77 when it was last driven and was still green, tested good and functioned...
He is using a second source out side of the norm hence the charges. if it was something he could get on the next "truck" there would be no charge.
unless you use the eec, no. Go to www.turboford.net and search there. More info on 2.3's than you can ever read.
excelent! Start your thread and get to work so I have something to aspire to. I want mine to do 125 too, just in the 1/4...
Ok so i am going to admit I work at advance auto parts... The autocraft gold is a good battery, cells are made by Johnson controls who also makes...
going to build a twin turbo y to get the brick over 100???
I dig the shit out of the look of yours. If I could roll mine out it should have a similar stance if maybe a couple inches taller. Good uni doors...
Well I have gotten a little deeper into my uni too. I got the bed floor cut out, front clip peeled off, rear suspension flipped and grabbed onto a...
Separate names with a comma.