The Jalopy Journal
Big 10-4 on that advice,learned that lesson the myself the hard way. I tried to pass that advice on to a friend on mine before he changed engines...
WOW! That must have been quite an experience to find that car after all those years. Congrats on being able to bring it back to the family. I...
[ATTACH] This might help.
To anyone trying to have a vehicle transported into or out of the northwest I would try Bats Motorsports (541-980-5885), they are located in...
Back in 69-70 when I worked at the local Sunoco station, I hated those low mounted filler necks that were behind the spring loaded license plate....
You really need to research your state laws on abandoned cars. I can tell you from personal experience, here in WV a property owner that has a...
They make T-connectors that plug inline with your existing wiring harness and have a pigtail for your trailer lights. Most auto part stores have...
Yea, it's good for wide variety of situations except for politics, then it's pretty much game on!
Bless those street rodders hearts For those of you not familiar with southern lingo this a polite way of saying, how stupid are street rodders!
I don't think your stater switch will work as currently drawn. You need to pickup 12 volts at the point you showing going to ground. This would...
I see your setup will have the fresh air being pulled in thru the air cleaner base, into the fitting at the rear of the block, thru the engine...
You can see squirrel run at 3:25 mark.
At some point I would remove that choke wire from your ign. wire and run it to a 12 volt source that is fused. The way it is now if your electric...
Spicer recommends a maximum of 3 degrees u-joint angle. They have this neat calculator on their web site. Plugging in your values your angles are...
I found this video on u-joint angles and driveshaft phasing. Something to beware of when setting up your driveline. The same principals would...
I think the death of Scott Kalitta was the beginning of the end for Englishtown. Sometimes the aftermath of such a tragedy just doesn't go away.
I believe KIWI KEV did exactly the type of swap you are talking about on one his builds. There is a thread here on the HAMB about it. Found the...
I got two valves for$9.99 free shipping on Ebay....
Read this thread on making you own gauge tester and how to use it to find what ohms range sender you will need....
[ATTACH]
Around 1985 I was at race where I was pitted at the fence line about 250 ft. from the starting line. There was a guy with barracuda parked beside...
I am pretty sure on the show they said they were American Rebel.
Brian Bass is going to be a quest builder at Gas Monkey Garage for a 60's style 34 Ford hot rod. The show is to be aired 10/30, 9:00 To 10:00 PM...
UB a lookin a long time for them parts
Before you get to far along with your build I would double check that the timing marks on the balancer your going to use and the timing indicator...
It It's a oil separator for the pcv system. Definitely should go back in if your going to use the rest of the pcv system.
This was the previous owner Sunny Chapman probably around 1980.
https://iowadot.gov/mvd/vehicleregistration/bonded-certificate-of-title Google is your friend.
They wouldn't work very well, you would have flip them upside down plus they have left-right taper also. Each one of the four taillights is...
Never under estimate Amazon....
Separate names with a comma.