The Jalopy Journal
One I built, copied from a picture I saw somewhere.[ATTACH]
Try Roberts motor parts or Andy Bernbaum for Heater shut off valve. Did someone switch the oil pan?
Sorry for your loss. I lost my Dad 9 days ago. It's been rough.
If I remember correctly, at some point, possibly when they went from B series to C series trucks the oil pans went from rear sump to front sump....
[ATTACH] [ATTACH] This is a '47 truck block in my '56 but I think it would be the same.
[ATTACH] Nice Job! I did single stripes with a makeshift guide and found it difficult to match up at the start finish. Yours look great.
[ATTACH]
I don't know if this helps because this is a 241 , but there is no hole in this block at that location. If nothing else I'll get you back to the...
I seldom use it and definitely don't have a full grasp on the use of it but, it has all of the scales labeled and directions on the back. [ATTACH]...
If this is any help , I did a search on Timken's website L68149 comes up with a 1.3775" id.
1.The truck bellhousing will bolt to the Plaza engine 2. The truck flywheel will bolt up as there are 4,6,and 8 bolt patterns, but they...
Ahh.. you are correct my mistake.
Dodge Truck VIN Decoder at http://t137.com/registry/help/decode.php says its from a 1961-62 M37B1
If I remember correctly the starter drive retracts when the engine starts and spins it faster, so on the bench the drive pops out but doesn't...
If it's a 70's truck rear, which it sounds like, you also have to watch the diameter of the axle where you want to shorten it to. They are a...
If I remember correctly, there is a spring in the latch mechanism that breaks, causing the issue. It's a clock type spring. Good luck trying to...
I like'em too. Painted a set of these up for my '27 T build.[ATTACH]
Yea I do, not sure what it came out of . The shift mechanism was somewhat unique. I didn't use any of it, the original truck linkage and shift...
I've got a '56 Dodge with a 230 and overdrive. With 3.50's in the rear it was okay on the flat but dogged pretty quickly on a grade. I switched to...
The general forum here will get you more information than being in the traditional hotrod forum, and P15-D24.com has a forum dedicated...
I agree looks like a mid 50's Dodge replacement engine. Measure bore and stroke as stated already. Check the head length 23 or 25 inches. The US...
The P15-D24 forum has this manual as well as others available for download. See if this link works for you....
Sounds like you are getting it figured out. I would do away with the by-pass switch and straighten out the wiring so it works correctly. On mine I...
Mopar 6 volt generators and starters have red tags, 12 volt have green.
Sorry no rear bumper on it, I don't think it ever had one. I do have a bumper I pulled from a '62 Dodge panel truck which looks the same, but the...
Sounds like you are missing these?
Just happened to have a picture of my door seals, taken before paint, saved. Here is the profile. Have a few more pictures showing where they are...
I have a set of early 40's spindles in the garage finally got time to check them. Looks like any 5/8-18 thread casle nut should work.
They make a device called a battery isolator. It's for charging multiple battery banks from a single charging source. Commonly used on campers,...
Separate names with a comma.