Signal-Stat 900 Sigflare turn signal help please

OK... I know... do a search...
My friggin' eyes are buggin' out from searching.

My F1 came with a nice "Signal-Stat 900 Sigflare" turn signal switch that has emergency flashers. I'm happy to say, it's time to hook it up. This switch has 11 wires coming out of it. Haven't found a wiring diagram with more than 8 wires.

The wire colors are:

1. blue (hooked to the internal reminder light)
2. yellow
3. white
4. black
5. green
6. red
7. gray
8. white with green tracer
9. white with red tracer
10. red with green tracer
11. gray with black tracer

I tore out the original hacked up wiring harness (turn switch wasn't hooked up) and I'm using a '68 Chevy pickup harness. Front and rear lights will be dual filament.

Thanks
Mark

 

thanks woogeroo.

but still looking for the correct diagram

 

Not sure, might be the 905/915 unit

but you might try.
Red = RF parklight
Green = LF parklight
Grey = LR taillight
Black = RR taillight
Yellow = flasher
Blue = flasher to light in switch?
Black w/Grey stripe = Stop light switch
Red w/Green stripe = Headlight switch dim to front parklights
White = Headlight switch to rear taillights
White w/Green stripe = LR taillight
White w/Red stripe = RR taillight

 

Your right.... The 900 series only has 7-8 wires.
SOOOO maybe someone switched housings.
I just wired one in my truck....
see post above for switch with additional wires.
You may have to do the "hunt and peck" method.

 

now I know why we are called gernade inspectors......

 

thanks Aquaroscoe

you do have the tail lights (park) listed twice for the rear


I'm guessing 2 of them should be stop/turn?

Grey = LR taillight
Black = RR taillight
White w/Green stripe = LR taillight
White w/Red stripe = RR taillight

 

I have a Signal Stat 900 with 11 wires just like the one listed previously. I'm trying to wire it in but I don't understand how it can control the headlights. The lever only moves up and down for the turn signals, but no other direction that might act as a high beam/low beam switch. I don't get the dual tail light wiring either. I've searched for a wiring diagram with no luck. Any help would be appreciated. Thank you.

 

it doesn't control the headlights. It uses the parking lights as turn signals, I think.

 

I'm sure your answer is in here from when I wired mine
https://www.jalopyjournal.com/forum/search/114261700/?q=Signal+Stat+900&o=relevance&c[user][0]=2398

 

The OP made the post in 2011. I hope he got this fixed before now.

 

Ha ha, got me