The Jalopy Journal
Will be there Friday. Looking for F1 Truck parts.
I use 1/2"x 2" strips (approx) cut from an old oil bottle to make support straps to hold my wiring runs. Wrap them around the finished bundle and...
Go with the 292. The 239 is not one of the typical Y-Block family (272, 292, 312). You won't be sorry. ...jack
I agree. Use Western Union Splice (twist and solder + shrink tube) on 14 gauge and smaller.
You might consider adding an adapter to your 3 or 4-bolt manifold and installing an Autolite 2100 or a Motorcraft 2150 carb. 8 different sizes -...
FYI: as of 8/21/13 there was a 48 tucker grill on EBAY. Just sayin, ...jack
Disconnect the vacuum line from the carb to the distributor and plug the carb end so there is no vacuum leak. Test drive. If OK now, the wire...
Hi Paul You've seen my bathroom, haven't you...jack
I have 2 Autolite 4100 4-barrel carburetors with stuck throttle shafts. Does anyone have any new ideas to free the stuck throttle shafts without...
Don't know what year. Who knows how many vehicles these motors have been in over the past sixty years. I thought all 8ba engines were the same...
I have a used flathead 8ba engine that i must remove to fix broken exhaust bolts. This engine will be used while i finish the rebuild on another...
If you decide to proceed with the build and the existing frame is not too rusty (or the rust can be cut out and repaired), box it yourself. Don't...
I agree. I do need an intake like yours. How do i get one?...thanks...jack
Separate names with a comma.