The Jalopy Journal
I set my toe by just using a tape on the front and backs of the tires -- same point on front and back -- 1/8" in. Came out fine and took out a...
I'm using a Chassis Engineering axle. It's forged. As 117harv said, this subject has been thrashed over and over several times.....
I agree, assuming the OPs wiring is correct, and the relays operate properly. If that is true, then: the OP has a bad motor (shorted) or his fuse...
The diagram is correct, and as 31 Vicky said, 87a should never be hot (it is grounded). Looks like a simple case of miswiring somewhere. FWIW...
I believe Johnny Law Motors is part of the Hoffman Group. http://www.jalopyjournal.com/forum/threads/autoloc-hoffman-group-etc.618388/ I don't...
[ATTACH] Seven inch section out of mine.... But for fiberglas flthd31 did it right. Seam will eventually show if its sectioned.
Yes, the wood pieces sit on the frame and go up into the subframe, and the body bolts go through them. Coat them with a good wood preservative...
Took 'er out Friday. Had no place to go but I went anyway
The white bucket was Fred Steele's, there's a thread on it ....
I'm not familiar with that switch but you really want one that closes both in park and in neutral -- my rod quit as I was going through an...
Tomorrow's date is 12-14-14 ... the last time this occurred was 100 years ago..... Oh never mind.
Looks like a few of those photos were taken at DVAP in N Phoenix... I was there some years ago.... http://lakeboon.com/dvap.htm
More unburned fuel getting into the exhaust on decel -- i.e. now running richer. Something has changed / is changing. Check your carb, is your...
For a permanent propane heater in your garage, install a direct vent wall furnace. Much safer, and you can leave it on all the time with the...
Separate names with a comma.