The Jalopy Journal
Increase the size of the feed gate, make it the full width of the casting body, no reason to step it down. Add clear vents to each of the 3 bosses...
And end mill is probably your best bet, but here is another suggestion: Put the blade of a straight screwdriver down into the hole and weld one...
since all threads are better with pictures... [ATTACH]
Now I know there's some attempted humor in this post, but I keep missing it - no matter how many times its posted. yawn.
Keep in mind the air we breathe is 78% Nitrogen...
You could also consider the earlier Jaguar XK150 16" wheels.
Just fixed 2 overheating issues with an OT vehicle (F-150) I noticed the temp gage creeping up to 3/4 when driving in 3 gear over 2500 rpm. The...
Ariel Square four motors are essentially 2 500cc parallel twins geared together at the crank. The simple gearing means counter-rotating...
Love your vision on the roof. Im sure you will work out any kinks with the mechanism. Have you tried getting in without a stepladder? :rolleyes:
Ah, ok. If you are running a 12v battery, a 12v coil with internal resistor, then its probably the condenser. But check the conditions of the...
This might be a clue. Is your generator running 12v? If so, you will need a ballast resistor inline with the coil, the spark at the points is a...
I think the right answer is a 30 amp fuse and separate fused circuits for headlights/ignition/horn, etc. There have been a couple of comments how...
The "CV" or constant velocity Zenith Strombergs had the square tops (not square body) that would compensate for air density/altitude. The CV carbs...
Separate names with a comma.