clutch disc help needed..11inch for GM t-5?

[mecutem]

I am helping a buddy get his little deuce 5 window running. SBC with truck bell and camaro 5 speed. We have a new truck 11 inch flywheel. He had a tranny shop change over a camaro trans to S10 shifter. Now the puzzle is finding a 11 inch clutch to fit the t 5 spline and pressure plate to fit the 11 inch flywheel. Anyone been there and done that? We may have to go to a smaller flywheel but I hope there is another way. Thanks for any help Steve

[roadstar]

There is a clutch rebuilder in this area called Clutch Masters Inc. They might be able to make it for you. They have made up some different combinations for me in the past.

1 586 759 1300

[mecutem]

thanks Roadstar......I will call them monday Steve

[Phil1934]

From the inliners site try mid '80's Astro van

[choprods]

PUT IN A READILY AVAILABLE 10-1/2" CLUTCH DISC [FOR THE 26 SPLINE INPUT]AND USE IT WITH THE 11" PRESSURE PLATE.PROBLEM SOLVED.

[whizzerick]

From Stovebolt.com :
- S10 shaft is 1-inch 14 (splines) so I used a 11-inch flywheel and an '85 Astro Van 11- inch disc with a pressure plate from a small block. Used a throw out bearing from an SB but for a cast iron fork.
I hope this helps,
whizzerick

[mecutem]

Another obstacle over come with the generous help of fellow hambers! Thanks a bunch guys. Steve