Boring a flathead

[mercurymike]

If my machinist bores my flathead block with a machine that uses the crankshaft bore to index from, how does that work when flathead cranks are offset 3/16" I think.

[30roadster]

thats a great question.... and I want to know the answer. This is the "questions about the HAMB and computer questions" section. I know you are new here and your bio says your 65. Are you a computer savy 65?......If not and you need some help let me know. When you can and you get a chance you need to post an introduction click here (http://www.jalopyjournal.com/forum/forumdisplay.php?f=18). Re-post this question in the hokey ass message board. click here (http://www.jalopyjournal.com/forum/forumdisplay.php?f=5) and you will get your answer.

[Digger_Dave]

Fellas, I reposted this subject on the main board.
Dave
It's getting LOTS of "action!"