Manual shifter question

[41sled]

I have a question while handbuilding a manual shifter ... Whats the diamiter size hole that connects the shifter rod to the linkage... is that 1/2 or what?


steve-

[Wicked Death Chop]

man, that really depends on what trans you have. more info please!

[41sled]

I thought it for more Universial type trans... I guess either 3 or 4 speed trans...

[Wicked Death Chop]

this may sound like a very generalized answer, but just build it outta whatever you got, and make it fit! seriously. i know thats kinda like the "duh" answer, but im sure you can make anything fit.

use a "grinder" to slim it down, and a "welder" to build it up. you should be able to figure it out.

now, on the other hand, ill build one for ya in trade for that old chevy you got! http://www.jalopyjournal.com/ubbthreads/images/graemlins/ooo.gif http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif!
jeff

[choprods]

Half an inch is close- cause the rodsd are about 3/8"plus nylon bushings......sounds about rite.

[41sled]

K thanks guys... This is going to be a HAMB auction.. Just wanted to make sure before i start to drill...



steve-