A few flathead parts

[Glenn Thoreson]

I need a few parts to finish my '53 Merc engine to '42 Ford conversion. I need a wide belt crank pulley, ala '49 to '5? truck 8BA or 8RT. Need the oil pump drive cover plate, gear and shaft for a '49-'53 8BA/8CM engine. I need a stock intake manifold for a '49 - '53 8BA engine w/fill and draft tubes (3 bolt carb mount.). For shipping reasons, the closer to Wyoming the better.
I have a bunch of early flathead small engine parts and misc stuff to trade, also.
Thanks.........
Glenn Thoreson
Cokeville, WY

[Glenn Thoreson]

Thanks to the many folks who replied to this. There are too many to thank individully, though I've tried. All has been located and I've picked the ones I want, except a crank pulley. Still need that. Ideally, a 2 groove wide belt truck pulley. Thanks agian! :D

[JJeJJeMMa414141]

Thanks to the many folks who replied to this. There are too many to thank individully, though I've tried. All has been located and I've picked the ones I want, except a crank pulley. Still need that. Ideally, a 2 groove wide belt truck pulley. Thanks agian! :D
I think I have the pulley you are looking for.

It is off of a Ford truck, has two wide belt groves.

I don't know how to include pictures on this HAMB system but if you still need the part send me your email address and I will send pictures.

thx!