Gear problem/any thoughts

[onelow48]

I got this rear in a swap. I poped it open and found that the axles and spider gears were welded together. All I am
after the the ring/pinion. The all mighty 323. 411's gota go. I tryed a sawzall lost 4 blades. Any thought's?

[old beet]

JUNK.....OLDBEET

[onelow48]

Thats what I thought. Do you think a torch would hurt the
integrity of the gears. I have very little money in the rear, any vaery little in my pocket.

[old beet]

What kind of rear end? Where are you? What gears ya want?......OLDBEET

[onelow48]

I'ts a gm 7.5/8 rear. It came out off a Camaro, they also came out off s-10 older ones. I trying to get some highway
gears. Right now the rear I am running has 411's. I have a 3 speed trans and my tire is 25.8" tall.

[onelow48]

O soory! I am in Maryland.

[old beet]

Sorry yer so far away. I bet some guys near you would like the 4.11s. Maybe trade someone......OLDBEET

[onelow48]

Thanks for looking out! Just got a call from a freind. He
has a set he going to bring over, he's not sure what they are, but he knows the 75/8.

[jerry]

take BBFH and a chisel and split the housing off the carrier.


jerry

[onelow48]

I was going to try that. the axles are welded and their is no way to get the ring gear out. I was going to have a freind try torching it out. I may have found a set? If that doesn't plan out I my just start going to yards and start poping off covers one @ a time.

[jerry]

after you bust the housing apart you can torch off the axle away from the gear set and slide the ring gear off the end of the torched off axle. just needs some creative desruction to get to where you need to be.


jerry

[porknbeaner]

Torch it apart where the axle tube meets the housing, then beat the axles out?

If you have no luck, I think I have access to some airplane gears for that rearend. Drop me a note if you need to.

[bustingear]

Welding the Spyders is poor mans posi and an old stock car trick. It makes for better handling out of those corners. Tried it myself and liked it....until the weld snaps. That happed to me and I ended up with a T-Bone in my side and getting clipped so bad it bent the front frame rails.
bustingear Dallas

[sawzall]

tank

what gears are you wantin?? I have a posi rear axle out of a 79 camaro thats a 3.08 ratio.. maybe the entire axle would work??

I have been hanging on to it for awhile and may not use it for some time..


shoot me a pm or call

[Jeffie James]

yeah i got a thought, see what you need to do is, take that rear hold it over your head, shake it a little and if the gears dont fall out, throw it outside in the junkpile. that way we wont be tripping over it in the garage.