Can anyone ID this Intake?

[Wowcars]

Here is an old Edmunds intake we found at the shop over the weekend and I can have it, but I have no idea what it fits. THe ports are 1 3/8" in diameter. 8 1/4" from center to center. 19 3/4" overall length. On the bottom it has stamped "CHF 6F". Seems to be cast aluminum. A 5/8" port running on the outside under the carbs. Thats all I know. Any ideas?
http://www.topperscarclub.com/albums/pileup03/MVC_041F.jpg
http://www.topperscarclub.com/albums/pileup03/MVC_042F.jpg
http://www.topperscarclub.com/albums/pileup03/MVC_043F.jpg

[RileyRacing]

If it ends up being for a Stovebolt, wanna sell it to me? http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif

Really.

Jay

[BigJim394]

It's kind of hard to tell from your pix, but are the flange plates where the manifold bolts to the head kind of triangular shaped (it kind of looks like that in one photo)?
If I remember right, that was typical of plymouth/dodge 6 cyl intake manifolds.

[TomH]

Ya getting anything done on the stude???

[Rainer]

think this one will fit flatty6 - same measures like my fenton (and this is for a 34 plymouth)

[whizzerick]

Dodge...
http://www.carlbest.com/dodge%20pics/redhead%20dodge%204.jpg

[kustomd]

I can't tell real well from the picture but it looks like either an old plymouth 6 cyl intake or possibly a 235 chevy six intake but it looks more like a plymouth though. I could be wrong about both though.

[36-3window]

are you sure about the number? that doesn't show up in my 1952 edmunds catalog

[Wowcars]

I think the intake is a lot shorter than GM 6 cylinders. Theres only one bolt hole in each of the mounting flanges, leading me to think that it also mounts with the exhaust with those bolt-through clamps. The Flat 6 Mopar sounds like a good place to start checking, tho

[4woody]

Replied email 1st by mistake. I'm pretty sure it is Mopar big 6. Not the 218/230, but the 237/251, 25 1/2 inch block engine. Port size and flanges are the same as on my 218, but other dimensions are longer. Usually would be on a Chrysler or Desoto, also used on some Canadian cars and who knows what else.

[sodbuster]

Here is a Dodge that was on Epay....

http://i13.ebayimg.com/02/i/00/f2/1a/3c_1.JPG
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&category=34198&item=24 44528766

[lucky_1974]

I don't know if it would work, but I have a running flat 6 Dodge motor out of a 1951 Coronet that I would let go real cheap...needs some freshing up but does run.