37 Buick front suspension upgrade

[HRay]

I am going where no man has gone before. So we get to the point. 37 Buick, has uprights and kingpins with independant suspension. Has lower A-arms, has single upper control arm. I want to modify the lower Buick A-arm to accept a chevy ball joint. Then install the chevy spindle, then set for netural caster camber, then position the new upper A-arm to allow for adjustment, then weld in the stock chevy bracket that will then hold the upper a-arm. This will give me disc brakes, keep me from clipping the front end. And give me all the existing hardware from the chevy to install. I am aware of not building in bump steer, aware of horziontal position of a-arms and tie rods etc.. Has anyone ever done anything like this. yea I know most people pay the 2K and go mustang II, but I do not want to cut out the existing cross member. Thanks for any websites or suggestions. Hray

[rustyford1]

You should post this on the main board. This is for questions and suggestions about the board. I can't answer any of your questions, but I can give some advice. Do an intro on the main board before the intro police get ya.