Local MO guys, I might need some help

[ELpolacko]

Pulling into the host hotel last night I heard a hard clunk from the front under braking.

Does anyone have a lift I can get my truck up on to do an inspection?

How about front end alignment equipment or a good shop to recommend just in case?

[ELpolacko]

Going down to check things out in the daylight.

Call me if you can help 602 885 1522

[ELpolacko]

MoKan Man has my back!

I think it may be something as simple as the anti-roll bar hitting the bumpstop on the frame. Nothing too tragic :) I am going to take the offer to get it on a lift to make double sure.

[Hot Rod Ron]

So what did you find out and how did the truck run up to that point?

[MilesM]

Just I40 / I35 or did you stop at an autocross event in route?

Killing me not to be there.

[ELpolacko]

Miles, it's perfect here... LOL

Got it fixed. The guys over at Comer's Exhaust let me use the pit and found the left rear shock stud gave up. I would put money on the OKC section of I-40 as responsible for that, that highway sucks!

We sawed a bit of the bumpstop tab off for extra clearance. Seemed good when we left but still made the clunk. We stopped off at a car wash and just thought to try and tighten the upper control arm bushing nuts, got about a half turn out of each one and it's all good now.

Beer has been bought, just saw FlamedAbone and DW show up. The drags are on!

[Tman]

Have a few for me!

[gonmad]

aww, I was hoping that you were going to say that you needed a couple smaller turbos to trade or something!! Lol. I was going to help ya out for that!

Glad it was nothing bad tho!