Old School Guy
08-03-2009, 09:34 AM
1932 Ford Roadster, As you can see in the picture, These Bodies are little different than any you have seen before, The mold was taken from a 32 and is still dimensionally correct, But was modified and altered in the rear wheel area, The rear wheel wells has been raised about 5" and made a little bigger, Now you can use 24" wheels on it, But you don't have to, 15" wheels big tires look good on them also, The wheel tubs have been moved in about 3-1/2" on both sides so you can run a wide tire & wheels with out it sticking way out like the other cars you see, The Frame is also totally made custom for these bodies, It is made just like any other modern, Boxed 32 frame until it comes to the rear, It to is narrowed a total of about 7" and is custom made with a huge C notch so the car will set Supper Low, The frame has a tubular x member and a tubular rear cross member, The transmission mount is adjustable and removable and is set up for use with a GM. 350 - 400 Transmission, The motor mounts are for a small block Chevy, They are not instated and not like the ones in the picture, The frame also has a Vega steering box mount installed on it, The front of the frame is set up for a dropped tube or dropped I beam axle, The rear of the frame is set up for coil over shocks, also the grill shell does not come with this deal, It is in the pictures for display purposes only, You can build these cars super high tech or build an old school rod out of it, They look cool ether way, As you can see in the pictures these are a smooth body, Like all new fiberglass body's, They will need the seam marks sanded down, But they don't need much, Each one is hand laid using the best fiberglass and materials available today, And they do have core matt in the floor to make it very strong and safe, These bodies do have a lot of steel supports throughout the entire body, Each one of these bodies is made by hand one at a time the right way here in IL. with pride and much attention to detail, The body comes with a brake peddle assembly, The dash installed, Doors and Trunk Lid Hinged & Latched, Also the trunk hinges are adjustable, This Body & Frame is nice, The price is $6,400, Also, I do have a new (Complete) Dropped Tube Axle with (All Parts) Spring, Chrome Hair Pins, Disc Brakes, I also have a (New) Walker Radiator for this car, I may have some other parts for it, I would have to look, These parts don't come with the car, But I will sell them at discounted price if you want to buy them with the car, I also can make this a roller if you want to buy it that way, Call 217-370-1687