mII arm length

[homebrew]

I need the length of stock mustang II upper and lower a arms from center of cross shaft to center of ball joint. I do not have a set to measure.
Thanks cj

[old beet]

Upper 9.5 Lower 14 inches, about , sort of, kinda......OLDBEET

[homebrew]

I am setting up a homebuilt coil over using mII width and for the spindle to spindle come out correct I am getting 7 3/4 top and 13'' lower using Elpolacko's 21 3/4'' lower measurement and 28'' upper. I am not sure if this is correct.

[old beet]

Just measured again, Stock arm Mll under my F-1. 9.5 and 14 is close........OLDBEET

[homebrew]

Thanks but i can not make it work. I think i will sleep on it and hunt a mII tomorrow.

[choprods]

as a side note: you CAN narrow the stock MustII dimensions[read that crossmember] BY 2" and still use stock tie rod ends and stock width RACK and Pinion.It will adjust to align still with that much reduction in width

[homebrew]

I got to talk to fatman and he said his new tubular arms are 7 1/2 on top and 13 1/2 on the lower.
thanks cj