2tall2beahotrodder
09-03-2004, 09:16 PM
Ok, if any one cares.. Been busy, but theres some progress.
-Started the Bondo work on the Passenger side...an hour or so will finish it up.
-Striped Pretty much the whole body. Cowl was really Pitted. But i mannaged to get it "roughed" out.
-Fited the Driver side cowl panel. This side was a little hard to get even. but i did the best. Pretty much all welded up.. Once again, give me an hour and itta be done.
- Grimlock got me thinking about dash ideas..
So i took a long peice of angle iron, welded it to the body for support. Then made a nice cardboard template for the dash. I used a Peice of welding wire, bent to my liking for the curves. Cut it out, and finished it by 4 nice finishing Washers. Looks pretty cool... More "batman-ish"
Heres the pics..
-Started the Bondo work on the Passenger side...an hour or so will finish it up.
-Striped Pretty much the whole body. Cowl was really Pitted. But i mannaged to get it "roughed" out.
-Fited the Driver side cowl panel. This side was a little hard to get even. but i did the best. Pretty much all welded up.. Once again, give me an hour and itta be done.
- Grimlock got me thinking about dash ideas..
So i took a long peice of angle iron, welded it to the body for support. Then made a nice cardboard template for the dash. I used a Peice of welding wire, bent to my liking for the curves. Cut it out, and finished it by 4 nice finishing Washers. Looks pretty cool... More "batman-ish"
Heres the pics..