Model A 2 1/4 inch wishbone to a 2 in axle

[RenoRat]

Anyone know what to use to make a spacer to adapt a model a wishbone to a 2 in old superbell axle? or know where to buy one??

Rich

[NealinCA]

I machined some 1/4" thick spacers on a lathe for my dad. I used 1-3/4" solid round and cut off two 1/4" thick slices.

You could use 1/4" plate. Use a holesaw to cut out two washers with the correct outside diameter to match the wishbone and axle ( I think I ended up at 1-5/8"?), then drill the center to the correct size for the perch.

Neal

[Paul2748]

Speedway has a spacer

[modernbeat]

I was going to use an aftermarket bottom shock bracket with a little modification.

[fab32]

If anyone you know has a lathe it's a 10 minute job to turn a couple of spacers.

Frank

[RICH B]

A pair of 3/4 AN washers on each side is easy way, small outer diameter and the
3/4" hole fits the 11/16" perch bolt OK.

[swissmike]

I would imagine the guy figured it out in 7 years...

[flatford39]

I would imagine the guy figured it out in 7 years...

That made me laugh out loud...Great catch there.