Anyone using a Nailhead to 350/400/powerglide adapter?

[suedesled]

I'm building a mid plate for my dragster and need a tracing or a schematic of an adapter just so I don't have to do the research. If someone can make my life a little easier on this project I would appreciate it.

[oldchevyseller]

well here is the info, it is more than just an adapter plate though
http://www.transmissionadapters.com/Nailhead_install.htm

[suedesled]

What I need is a schematic or a tracing of the bolt layout. I need to make a mid plate. The adapter kit won't work in a dragster. It's a good lead though, Thanks

[zman]

I've got a bellhousing I can trace if that would help...

[suedesled]

I was thinking of that but what I need to do is make a 1/2" plate that is Powerglide pattern on one side and 401 on the other side while keeping the input shaft in alignment with the crank. I can do this by turning an alignment shaft on a lathe to bolt to the crank and trace them out. I wasn't going to buy a kit that I would never use but i want to get this car together in the next few weeks. Thanks Zman