toyota motor update!!

[DIRTYT]

so i got the 4 inch wide by 1/4 inch plate steel today for the motor mounts and got all the wireing shit figured out i think. this weekends goal is to hope fully get the mounts made and mock up the s-10 rear end and tranny. any one near me (detroit) have a plazma cutter or a band saw that can cut these mounts for me so i can weld them together???

[Fat Hack]

I got a hacksaw and some dull blades...it'll give you a HOBBY! http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif http://www.jalopyjournal.com/ubbthreads/images/graemlins/tongue.gif http://www.jalopyjournal.com/ubbthreads/images/graemlins/laugh.gif

[DIRTYT]

u and that damn hack saw lol if it comes down to it the sawzall and a grinder will do as well..