mytlo56
10-04-2003, 01:29 AM
Howdy all. I'm wondering what the flow rate in PSI's would be on a stock replacement mechanical Y-Block fuel pump?
As I'm sure many of you have read, I'm building a gas injection flame thrower for my 56 Vic. I have come across a diagram that claims that you are able to run a t fitting from near your fuel pump directly to the solenoids that direct fuel to the nozzles at the tips of your exhaust.
I'm having a hard time believing that the same pump that is flowing to my carb could simultaneously create enough flow to get a good spray from the nozzles, especially being mechanical & likely low flow.
Thoughts everyone...
As I'm sure many of you have read, I'm building a gas injection flame thrower for my 56 Vic. I have come across a diagram that claims that you are able to run a t fitting from near your fuel pump directly to the solenoids that direct fuel to the nozzles at the tips of your exhaust.
I'm having a hard time believing that the same pump that is flowing to my carb could simultaneously create enough flow to get a good spray from the nozzles, especially being mechanical & likely low flow.
Thoughts everyone...