looking for a good machine shop in northern nj

[Slag Kustom]

im looking for some help machining an offset custom sprocket for my blown nitrous sportster. every time i try to pay a shop to do some thing it never ends up getting done . I have been building this bike for over 7 years stoping all the time to build other cars and bikes but i think its time to get going again.

[Foul]

I'll ask at work tomorrow morning. Couple guys on staff from that area.
dan

[Flatdog]

Where in northern NJ are you and what exactly do you need done in machining terms? I'll ask around, I know a bunch of machinists in the area.

[Slag Kustom]

i need to take 2 sprockets machine the center out of one (to use the splines) use the teeth of the other , have a tube about 3/4 of an inch made to weld them back together and also accept a bearing in it to suport the offset. i have plans drawn up with all the sizes and the sprockets and bearing

[Flatdog]

Sounds like child's play, where are you at?

[Slag Kustom]

it seems that way to me too but it is as if my money is no good. i had the bike sit at one machine shop for 6 months just to get the custom rear axle made. im in mahwah

[Flatdog]

Call me at work tomorrow, I can probably do the job for you this weekend. 973-627-6110

[Slag Kustom]

cool thanks alot ill give you a call tomorrow around noon