Mass Butcher
06-29-2004, 02:29 PM
http://www.outlawrodparts.com/images/53pupics/100_0435.JPG
Almost done! Even though I fit the motor before welding in the motor mounts the stock mechanical fuel pump don't fit, so I had to plumb in an electrical one. I just have to run the tranny lines, then start putting the nose back on. I need to have my driveshaft cut, but I should have it on the road for the Road Agents show coming up.
Almost done! Even though I fit the motor before welding in the motor mounts the stock mechanical fuel pump don't fit, so I had to plumb in an electrical one. I just have to run the tranny lines, then start putting the nose back on. I need to have my driveshaft cut, but I should have it on the road for the Road Agents show coming up.