Engine Turned Aluminum

[Low]

Ok, I now have two 4'x4' sheets of 5051 .062" aluminum with 7/8" swirls of engine turned aluminum for sale. The full 4x4 sheet is $200+shipping. I can shear these up into smaller pieces if desired, and I will sell smaller pieces PM for additional pricing. Thanks for looking

Sam

[Low]

bump

[Low]

Update. I now have one 4'x4' piece of 1/8" 5051 aluminum with the same pattern as above. The 1/8" is a little pricier it is going for $260 for 4'x4'. I can turn more of this if you need it, as well as shear it to size for you. PM for additional pricing. Thanks for looking.

Sam.

EDIT: SOLD OUT of 1/8"

I have just added some .090" pieces to my stock. PM for pricing details.

[36DodgeRatty]

Any Stainless?

[Verboten Wookie]

nice!
I have ben experimenting w/ this! I would like any tips you can give me So far it's tools and smaller items that I've been using a gun kit to do. Id like to know wht you've used for larger dia/pieces. I was going to try bolting an old countertop to my press and putting a fence on it that i can slide to keep my lines straight.. Any help you can give is appreciated. VW

[Low]

top

[maconga]

I know your post for engine turned aluminum panels is dated. Do you have any engine turned aluminum today? If so how much for 4 panels measuring 15" x 36"? You may contact me via email at: rmsonly@hotmail.com Thanks Richard

[maconga]

Do you still have engine turned aluminum panels?

[T2Vracing]

Do you have panels ??/
I need a 4' X 4' panel
Thanks
T2V racing restoration

[Low]

sorry guys. not doing this anymore.