flathead intake diagram

[kustomkoupe]

does anyone have a schematic or flow pattern drawing of a stock ford flathead intake...59AB and 8BA if there is a difference...im working on figuring out how to make this supercharger work for even fuel dispersing...and making sure there is enough to cylinders 1 and 2 because of the overlap of #2 exhaust and #1's intake...i may end up just makiing my own intake similar to an ORD but so that the main center area is level rather then paralell to the top of the block also make it so it has a weld sem around the paralell center so i can weld and polish the inside before i weld the top on...anyways id just like to see the flow pattern of a stock intake as too see what i can come up with with that design and running the supercharger right into the top of it

thanks
zach

[Big A]

Lots of flathead technical info here...

http://www.btc-bci.com/~billben/flathead.htm

[kustomkoupe]

thanks big A i haven;t seen that site before

zach

[Digger_Dave]

zach, you don't say what kind of blower your planning on, but the manifold for my SCoT blower is just an open chamber with holes to feed the intake ports. Blowers will overcome minor inbalances because air/fuel is pressured at the valve.