PDA

View Full Version : 62 Buford

xfordman
07-30-2007, 05:23 PM
I,m new to this thread posting stuff, so bear with me.I'm redoing an aluminum block(215) Buick, and broke a head bolt AND easy out on #3. I don't think it's retievable. Any method for welding stud to the broken bolt?I'd hate to traash the block as the're gettin kinda scarce.
Chili Phil
07-30-2007, 06:27 PM
If you ain't putting that engine in a Ford, don't call it a Buford. We get testy about that here.

Take it to a machine shop.
oldskol
07-30-2007, 06:36 PM
Xford a machine shop at this point would be your best bet. What part of Nevada are you in? AIMS machine shop in Reno, Nevada is a top notch machine shop that will take care of your issue.

If you ain't putting that engine in a Ford, don't call it a Buford. We get testy about that here.


Xford call you ride what you want. No matter what setup you are running.....;)