New Guy W/41 Ford Sedan

[TIM JOHNSON]

Been building car for a year and a half now. FInal stage of assembly. Putting in wire harness and interior in the next two weeks. Rush time now.... Is this the right place to ask for help? I have put in a 302, C-4, 9" rear end. Trying to use orginal gages, put in voltage reducer, changed polarity, need to know what temp sender I can put into 302 block and send similar signal that orginal Flathead sender sent to gage.
Thanks

[walrus]

Tim, Welcome to the HAMB, Nice to have you on board, Good place to ask questions while you build and give advice after you finish,,,,,,,

[mister moustash]

I Also Have A 41 2dr Sd I Will Be Converting To 12vts Soon Im Running The Flathead Good Luck If I Come Across Info Ill E Mail Ya

[416Ford]

Welcome aboard Tim, building a 46/41 with similar combo(4 dr), not running the original gauges so I can't help you there. Mine was originally a 46 but I have changed the dash and front end over to a 41 due to looks. Check out the tech section on the gauges and there may be some help there.