Nailhead 6x2's and EElco

[suedesled]

I would like to thank everyone in advance for the opportunity to use this forum. I signed on a year or so ago and don't visit very often but now that we are relaesing parts that are familiar to this group we(NW Speed) would like to take a moment to introduce the company.

It started because we couldn't find parts for the traditional rods we love. So we made them like most of you do. Then an opportunity to buy Eelco arose and we have accepted the challenge to make it everything Els Lohn believed in. We currently produce 14 different linkage kits, fuel caps, jet plugs for Strombergs and are working on the fuel tanks now.

The 6x2's for nailheads have just been finished and we are working on Stromberg 97's with Stromberg(England). Also in the works are early Cad manifolds and Nailhead aluminum heads! We are alsways open to ideas and input, Our parts are 100% satisfaction guaranteed. Look for us on the pages of Street Rodder and Rod & Customs.

Take Care, Enjoy your ride (what else is there?)

[zman]

So you just deside your gonna spam now. Bright idea there.

[Offy]

I think it is useful information on new products. Thanks

[zman]

Well sorry but I don't know if I can take the word of someone who has yet to do a proper intro..... http://www.jalopyjournal.com/ubbthreads/images/graemlins/wink.gif

[suedesled]

I introduced myself 2 years ago and just did it again with this post. Thanks to all the real hot rodders out there for all your support and positive interest and ideas.

[flt-blk]

I have a 4 hole Eelco fuel block that my dad used to run on
something. It proudly feeds fuel to 3 carbs and a gauge on
my car now.

I like to hear about old speed equipment becoming new
again. Do you have a web site up yet, I am asking so it is
not spam if you post it.?
TZ

[slazzen]

i would like a source for the little cast ends???? i know offy sells them for about $4 i figure they make them for copy machines still so there has to be a cheep source???? $150 for some rod and a few $4 ends is steep!!!! like you said in your post we will just make it!!!! any one know of a cheaper source than offy for the ends ??? if not i guess its around $40 to make a 6x2 linkage .