FS 55 Chevy racecar project

[Larry T]

Backhalfed 55 Chevy with full rollcage. Steel quarterpanels, roof and cowl, the rest is new fiberglass (fenders, hood, doors, bumpers, and trunklid). Narrowed 9" Ford rearend, will work with 10.5" to 14"+ tires, depending on backspacing. New S&W adjustable ladderbars, coilover kit. Engine plates and fenderwell headers for bigblock Chevy. New stainless trim and lee taillight lenses. PM for more specs. Thanks.
Larry T

[Larry T]

Hey folks, I've had a couple of e-mails looking for a 55 gasser to put on the street. While it could be done, it'd be a lot of work with this car.

Here's a picture of why. The rear end is in the car now, but it has a spool in it.

Sorry I didn't make this clear in the original post.

Thanks,
Larry T


http://img508.imageshack.us/img508/7980/55rear3rk5.jpg (http://imageshack.us)

[Larry T]

I need to sell this to get back to work on my Anglia.
Carb and intake DON'T go with the car.
Larry T

http://img27.imageshack.us/img27/1346/engine554xp1.jpg (http://imageshack.us)

[Larry T]

Well, this was supposedly gone, but.........
I guess I'll bring it to the top again.
Larry T

[Larry T]

I just noticed this is still sitting in the corner. I could move it to the barn if it would help sell it. LOL Sure could use the space and funds for projects I'm really trying to work on.
I've got new Moroso springs and new ball joint spacers to bring the front end up. Rear end is adjustable coil overs, so you could set it at any height you wanted.
Larry T