Who makes these lower corners for a '30?

[injectedA]

Would like to have them by this weekend. Thanks.

[lownrusty]

Try Mac's antique auto parts 800-777-0948

[Smokin Joe]

Home Depot has both the chicken wire and the bondo you'll need. http://www.jalopyjournal.com/ubbthreads/images/graemlins/tongue.gif

Ngo Long Dong probably makes them. http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif

Try Macs or Snyders.
http://www.snydersantiqueauto.com/
http://www.macsautoparts.com/

[injectedA]

As I've become a billet queen I have both of their catalogs and wasn't seeing them. I'll slow down and look again. Thanks.

Joe quit smokin. http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif

[DrJ]

Sounds like you are hot to weld them in...!
May I suggest you have the trunk lid and apron handy because they must align with the bottoms of those corners and since you don't have any it might be difficult to figure out how far up or down they go without using the panels that go between the corners to line them up.

[Paul2748]

Snyders Antique Auto parts, Springfield, Ohio 888-262-5712. Page 82 of their catalogue. 29.00 per pair

[Smokin Joe]

I thought my trunk floor was bad! You've given me hope...
Order the sub-rails and the bottom edge under the trunk at the same time.

[injectedA]

Page 29, gotcha, thanks.

All I need is the corners. Can't roll that bead form. As for the rest? I engineer commercial HVAC and the shop downstairs loves me. Working drawings that they can USE helps. Plenty of beer helps also. Damn union labor. http://www.jalopyjournal.com/ubbthreads/images/graemlins/wink.gif I'll do the lid, pan and floors there. Again, many thanks.