PDA

View Full Version : question.. what rotors fit my econo axle on my gasser?

radical56chevy
03-09-2004, 12:07 AM
i have a econoline axle under my gasser i'm trying to get the brake stuff i need to put on my axle..its a mid 60's econoline axle..any help would be greatfull..i would like to put disk on if possible..but will run drum if have to,,
radical56chevy
03-09-2004, 12:54 AM
http://www.jalopyjournal.com/ubbthreads/images/graemlins/grin.gif
DrJ
03-09-2004, 02:13 AM
If it's for race only don't even run front brakes. If you're running the beam axle because it's lighter than all the IFSparts then drums are usually lighter than disc brakes, so run drums. At least that's what I'd do.
Rob Lewis
03-09-2004, 09:43 AM
http://ford-econoline.com/phpBB2/viewtopic.php?t=739
38Chevy454
03-09-2004, 11:08 AM
That link for the Econoline disc kit seems to show using the stock hub and a hat type rotor, maybe from a Jeep? Or other Ford rear disc brake like an Explorer? The caliper looks like a standard Delco Morraine caliper used throughout the 70's and 80's. Simple bracket that uses the backing plate bolt holes and mount it all up. A good design from what I can see.

That said, why not run the Econoline stock drum set-up? If you are building a gasser, that would have been the era-correct brakes used. Econoline drums are extra wide (like 2.5 inch wide shoes) and would seem to have plenty of braking, unless your car is real fast. Only drawback is that Econoline drums are junkyard only, they are not available new. So if yours are missing, then the disc kit may be the way to go, but I think you still need some hubs to start.
radical56chevy
03-09-2004, 02:26 PM
dr j...gonna be driving on the streets ..no real racing to be done..

38chevy... all i have right now is the axle..the drums where wasted ..thats why i figure go disk..smoother stopping..not having to adjust them to keep it straight on stopping.if i could find the drum stuff new i'de consider it..thanks for help..
radical56chevy
03-09-2004, 02:27 PM
rob...thanks for link.. looks like a decent set up..
butch27
05-11-2005, 09:51 PM
1970 to1977 GM rotors will fit using the stock Chevy bearings. Just add a 1/4" spacer between the outer bearing and the stock flat washer. CHANGE the inner grease seal to CR#17406. Use and Intermediate GM calipers like Chevelle- Nova- Regal- Cutlass- Monte- Firebird. This is what is in the kit I think they are selling. Priced OUTRAGE!!