do rod ends like this exist?

[rickyracer1962]

pulled this picture off the internet somewhere. anyone know where i can get a rod end like this? 1/4" fine thread?

[CURIOUS RASH]

<font color="green">Ricky,

They use those on cable assemblies in some aircraft.

Can't tell you where to find them but maybe you have some sort of aircraft salveage in your area?

RASHY </font>

[rickyracer1962]

aircraft huh? i'll do some more searching. not really any aircraft supply places around here.

[tootallrodder]

I Checked in McMaster Carr, but did not find them listed. Give an industrial beaing distributor a call I would not be suprized that thay are available. But if you had to you could alway have 2 nest to one another, Or even carefully weld a addition onto a standard one. Id it for a Throttle linkage set up?

[C9]

Bearing Houses usually carry Heims and rod ends.
Their catalogs show the double ones like your photo.

I'm sure Santa Barbara has a bearing house and if not, Ventura has one called, surprise - The Bearing House.
It's on the Avenue, West side about 2-3 blocks north of main.
Just above where Prossers Bakery is - or used to be....

Give em a call.

[ESnacky6]

Ricky- Try Specialty Tool in Goleta..!!

When I lived in SB they were THE place to go to find just about
ANY odd or unusual fastener at all...

(plus they're right across from the airport...)

[rickyracer1962]

yeah specialty is good, but the last couple of times i went out there they let me down. plus the cute blond dont work there anymore. check your email.

[ESnacky6]

thanks Ricky, I'll show Flip when he's free...

[OGNC]

or you could check out this site and see if they make them right here in the net...
FK rod ends (http://www.fkrodends.com)